Tag: water

Surprising Pool Maintenance Tricks

Use a Bucket to Track Water Usage

Environmental factors, like temperature, and humidity, dictate the rate at which the pool loses water. However, average water loss should not be more than twenty-five percent of an inch daily. To measure the rate of water loss, place a weighted bucket on the stairs and mark the water levels at different intervals throughout the day. Significant margins are an indication of a leak in the pool, which you should have repaired. If the water levels are lower than what you would like, simply use a hose pipe to fill up the pool to the required levels. Remember to check the chemical levels after each refill.

Use a Line and Net to Remove Dirt

Loose dirt that finds its way into the pool can be removed by skimming, using a net fixed to a line. However, dirt, residue, and contaminants may stick along the tile area and water line, necessitating proper cleaning. Dedicate yourself to cleaning this area at least once per week to reduce calcium build up. As you clean the tiles, also remember that the walkways need to be cleaned too to minimize chances of transferring grime and dirt into the pool.

The Filter is the Kidney of Your Pool

If you do not adequately take care of this small, yet crucial part of your pool, eventually you may end up with a dead pool. In the same way the kidneys are responsible for removing impurities, so the filter is designed to remove contaminants like leaves, dirt, and small debris from the water. Once a month, it is advisable to clean the pipes in the filter system. A simple way to do so is to backwash by removing the leaf basket and turning on the pump and letting it run till the pipe discharges clear water.

Ensure that You Maintain Consistent Chemical Levels

This is one of the most critical factors in proper pool maintenance. When the water lacks proper chemical balance, it looks murky, irritates skin, and can harbor bacteria. It is recommended to test the chemical levels weekly. The chemical levels to be tested are cyanuric acid, free chlorine, total alkalinity, acidity/alkalinity, and calcium hardness.

Get a professional to do the testing for you. If you want to do it yourself, buy the testing kit from the local pool store and follow the attached instructions. Chemicals that are well balanced make your water very clear and produce no smell and leave no residue on the skin.

It is also recommended to “shock” your pool. This refers to raising the chlorine levels of the pool suddenly but for a short time. The technique is useful in killing bacteria, and the way to do this is to dilute five times the usual amount of chlorine with water and then slowly pouring it into the swimming pool. A few minutes later you refill the pool with water to restore the normal chlorine levels. Shocking increases the risk of damaging the pools siding, and that is why it is recommendable to limit the process to no more than two times each season.

Check the Condition of the Skimmer Lid

Occasionally it is necessary to replace the skimmer cover in case it gets cracked or broken. It plays an important role by preventing people or pets from falling into the skimmer well so it is important to ensure that it is in good condition and firmly fixed in position. During replacement, ensure that the power to the pump is turned off to avoid accidents.

Power Wash

This is also known as pressure washing and the process helps get rid of weather stains and any rust that can occur over time. The process begins by sweeping the deck clean to make it free of loose dirt so that it does not spread all over during cleaning. Set the power washer to medium power and spray the surface to remove all debris, doing so over and over again until the place is thoroughly clean. A power washer can be rented from the local pool store.

Ensure You Schedule a Yearly Service Appointment with an Expert

You may not think that it is necessary, but the knowledge you have may not be sufficient for the care of your equipment like filters, pumps, and heating systems. A professional pool service provider will not only check your devices but also advise you on what you need to improve to keep your pool in good order. They can quickly detect small problems that might cause a massive crisis in future.